1.
Bulk coil 200 linear feet minimum. Bulk coil may be ordered in long lengths
or in specific cut-to-size pieces. U.S. Liner Company reserves the right
to manufacture and ship total linear footage of long length bulk coils
within the following parameter lengths per piece:
| Product |
.050" |
.070" |
| Min. |
200' |
200' |
| Max. |
800' |
800' |
U.S. Liner idetifies all pieces of BULITEX with an exclusive BULITEX label,
indicating which side faces cargo.
SPECIFICATIONS:
BULITEX panels are manufactured
by a continuous laminating process and cut to desired lengths.
Panel edges and fastener holes need to be properly sealed to prevent water
penetration.
COMPOSITION:
BULITEX
is a thermoplastic composite using multi-layered woven fiber technology.
Finished panel quality:
1. Panels shall be made of the composite described
above and the wear side shall have a smooth, woven finish. Back side imperfections
which do not affect functional properties are not cause for rejection.
2. Physical properties shall be as set forth in Table 1.
3. Product quality standards and tolerances for panel weights and thicknesses
for each series shall be as determined by U.S. Liner's Quality Control. |
|
Width: +/-1/8"
Length: +/-1/8" up to 12', + 1/4" from 12' to 40', bulk coil
-0" and +6"
Squareness: 1/8" in 4'
NOTICE:
BULITEX
panels will provide a clean, aesthetically-pleasing finished installation.
However, by nature, composite paneling may occasionally have small areas
that are not acceptable for use. All panels should be inspected on-site
prior to installation. If any portion of material will not provide an
acceptable appearance, U.S. Liner Company should be notified at once.
Upon verification of unacceptability by U.S. Liner Quality Control, that
portion of material will be replaced by U.S. Liner. U.S. Liner's sole
responsibility is for the replacement of defective material, but not for
labor or other handling or installation expense.
NON-WARRANTY:
U.S. Liner believes all information
provided herein is accurate. It is offered in good faith, but without
guarantee. Since conditions of use are beyond our control, all risks are
assumed by the user. Nothing herein shall be construed as a recommendation
for uses which infringe on valid patents or as extending a license under
valid patents.
BULITEX
is manufactured exclusively by and is a registered trademark of U.S. Liner
Company.
 |
